Ahnlab: Firewall

show policy | include <destination_ip> show app-control status Move the rule higher in the GUI ( Policy > Rules ) or temporarily disable IPS/App-ID for that rule. 3.2 "High CPU / Slow throughput" Check:

| Task | Command | |------|---------| | Enter config mode | configure terminal | | Show running config | show running-config | | Show interface status | show interface or show ip interface brief | | Show active sessions | show session table or show session count | | Show firewall rules (policy) | show policy or show access-list | | Show NAT rules | show nat | | Show routing table | show ip route | | Show HA status (cluster) | show ha status | | Show system log | show log system last 50 | | Show traffic log | show log traffic from <IP> | | Ping test | execute ping <target_ip> (from operational mode) | | Traceroute | execute traceroute <target_ip> | | Save config | write memory or copy running-config startup-config | | Reset session (force logout) | clear session source <IP> | 3.1 "Internet works, but specific service is blocked" Likely cause: Policy rule order or Application Control. ahnlab firewall